Cattleya Orchid

This orchid is a flower in between the many types of cut flowers in the world. This does not take the plants need a wide area. Behind the house also can. Pembudidayaan and maintenance Cattleya, not too complicated. When properly maintained, and regularly does not usually show a lot of obstacles. This major is sprinkling Cattleya maintenance, fertilization and spraying anti-drugs should be a pest. The sequence of events for membudidayakan Cattleya as follows: 1. Preparing Cattleya orchid cultivation of land, usually built special rooms, such as greenhouse or plastic house that there are shelves that can be stratified made of wood. The size of the building, which is adjusted to the plant akan dibudidayakan. 2. Cattleya orchid is an orchid that is planted with the pot. Thus the determination of the pot, as a growing media is very important. Growth media that can be used block fern, charcoal, batubata, coconut fiber, or pine bark. Usually material is cleaned, and soaked in a solution of fertilizer or pesticide. As an alternative, and also that the findings should be tested is the use of volcano stone (stone perforated holes / pumice) or the remnant fraction brick, we can buy the cheaper price in the brick. This fraction, cut small, or approximately 2-3 cm. Implantation stages in the plant to the pot; Prepare a pot of land, the size is adjusted to the plant. Then lubangi pot, so that the drainage channel is excessive. 3. Enter to grow in the medium pot, then take Cattleya orchid seeds carefully in order not to be damaged and broken. Tanamkan orchid seed, right in the middle of the pot timbun ago, or close to the medium is thin. Arranged so that not too full, so there is air entry and prevent root rot. 4.Tanaman always need attention, maintenance and special to be able to grow optimally. Especially a problem in temperature and light. In general, growth in Cattleya require temperature 22 degrees Celsius with the minimum temperature 15 degrees Celsius. 5. Do not be too Disiram temperatures too high, can cause dehydration or lack of water. Direct sunlight, if left akan leaf scorch. So light intensity is ideal for the growth of Cattleya is around 40-60% sunlight. To get a light like this, can we use plastic or zinc paranet. 6. Another thing that must be observed is, the problem of sprinkling and fertilization. On Cattleya, sprinkling should not be unduly often. Should be done two days once. For media such as a relatively dense fern, sprinkling should be done once a week. So basically, try to see the first medium. During the still wet, it’s not the first disiram also because the roots need a dry times. For fertilization, should be done two days once, either through spraying or sprinkling.
Various kinds of flowers